Two Gigabit Ethernet Copper Ports, 10/100/1000 BaseT, with Hardware Failover/Bypass

The ET/GigFailover is built on Intel's Gigabit technology, and is optimized to support 64-bit/133MHz PCI-X bus based systems. The hardware Failover/Bypass function allows systems incorporating the ET/GigFailover to eliminate single point of failure concerns by bypassing the system in the event of a power down or software lockup or failure. Additional features allow a system with the ET/Gigfailover to be temporarily taken offline, allowing for safe upgrades or maintenance even from a remote location. A functional description of the bypass function can be found here

Features

• Intel's 82546GB controller
• Can act as 2 port card or bypass card
• Two integrated PHYs for 10/100/1000 Mb/s full- and half-duplex operation
• Programmable Bypass - during power off or software failure
• PCI 2.2 and PCI-X 1.0 compliant, 32/64-bit, 32/64/100//133MHz
• IEEE 802.3ab, 802.3u, 802.3x compliant
• Host offloading options - TCP/IP/UDP checksum, TCP segmentation and advanced packet filtering
• Two RJ45 Connectors

Software Support

This card can be used as a plug in solution with ET/BWMGR appliances or as a standalone solution with a software bypass driver. If you will not be using the card with an ET/BWMGR appliance or CD appliance, you must specify in the comments field that you need the software as its not normally included.

• FreeBSD 4,6,7 Linux 2.4.x, 2.6.x
• Full Driver Module and Easy-to-use

 Dimensions

• Low profile PCI form factor (Low Profile Brackets on request with order)
• Length, 167.64 mm
• Height, 64.41 mm